Starting from UgCS 5.11, DJI Pilot 2 can be connected to UgCS over the internet using UgCS Cloud. This provides access to routes that have been planned in UgCS within DJI Pilot 2. Routes can be downloaded and stored offline on Pilot 2, thus allowing access to routes even without an internet connection.

How to Connect to UgCS Cloud

Sign up through UgCS Client

Open UgCS and click on the Cloud Icon.

Click on the Sign In button

Your default browser will open an authorization page. Sign in by entering your email address, pressing Continue, then entering your password and pressing Continue again.
If you're a new user, select Sign Up instead.

If Sign Up is required:
o Press Sign Up.
o Enter your email address and press Continue.
o Wait for the 6-digit code in your email. Enter it and press Continue.
o Enter your password and press Continue.
o Press Accept to authorize the login.
In UgCS, under the Cloud tab, you will now see that you are successfully logged in.

There are 2 modes available:

Push only - Data can be pushed to the cloud, but can't be pulled from it.
Bidirectional - Data can be pushed and pulled from the cloud. (Currently not supported)

Access Cloud services in DJI Pilot 2

Launch DJI Pilot 2 on your remote controller.
Select Cloud Service tab.

Select Open Platforms.

Connect to Cloud Service

In the address field, enter: https://cloud.ugcs.com
Press Connect.

Log in to your account

Enter your email address and press Continue.
Enter your password and press Continue.

Select Mission

Choose the mission you want to use from the list.

Select route from your Library

Return to the main screen.
Select Flight Route -> Cloud tab.
Select the routes necessary and move them into the local library storage. Then select, upload, and fly.

Note:

The UgCS Cloud doesn't stream any telemetry information from the drone to UgCS, such as location, battery level, and GPS satellite count. If you need a Telemetry stream from the drone to UgCS, then you need to connect DJI Pilot 2 with UgCS directly as explained here: https://manuals-ugcs.sphengineering.com/docs/connecting-dji-pilot2-to-ugcs