Log In

Connecting DJI Pilot 2 to UgCS


This feature is compatible with the following RC firmware and DJI Pilot 2 versions.

AircraftRC FirmwareDJI Pilot 2 version
M300 series06.
Mavic 3 Enterprise series02.
M30 series01.02.03.676.1.2.2

How to connect

  1. Install UgCS Desktop version 4.15 or higher and activate it.
  2. Make sure that the proper version (see “Compatibility” table) of DJI Pilot 2 is installed on DJI RC.
  3. Make sure both devices - computer and DJI smart controller are connected to the same network.
  4. Open DJI Pilot 2.
  5. Click the “Cloud Service” card.

  1. In the opened window click “Open Platforms”.

  1. Return to the UgCS Desktop application, click the “Add vehicle button” and select “Connect from DJI Pilot 2”.

  1. Displated URL will be needed in the next step.

  1. Return to the DJI Pilot 2, enter the URL from the UgCS Desktop and click "Connect".

  1. Wait until DJI Pilot 2 is connected to the UgCS Desktop.

  1. Select the Altitude mode.

  1. Return to the previous menu and click the "Flight Route" card.

  1. Switch to the "Cloud" tab.

  1. Now the list of routes from UgCS will be displayed.

Note: that only routes for M300, M30 and M3E will be shown.

  1. Select the routes necessary and move them into local library storage. Then select, upload, and fly.

Routes in the Cloud tab will be updated automatically when changes are made to the routes in UgCS.

Route names are in the form of - "Mission name: Route name"